![]() UPSERT in SQLite follows the syntax established by PostgreSQL. UPSERT is a special syntax addition to INSERT that causes the INSERT to behave as an UPDATE or a no-op if the INSERT would violate a uniqueness constraint. UPSERT support in SQLite! UPSERT syntax was added to SQLite with version 3.24.0! ![]() the NAME column will be set to NULL or the default value: INSERT OR REPLACE INTO Employee (id, role) Perhaps I should use the select to read the 4th column (Blob3) and then use REPLACE to write a new record blending the original 4th Column with the new data for the first 3 columns?Īssuming three columns in the table: ID, NAME, ROLEīAD: This will insert or replace all columns with new values for ID=1: INSERT OR REPLACE INTO Employee (id, name, role)īAD: This will insert or replace 2 of the columns. UPDATE I am guessing is slow compared to INSERT, but how does it compare to SELECT using the Primary key? ![]() Destroy the statement object using sqlite3_finalize().Reset the statement using sqlite3_reset() then go back to step 2 and repeat.Bind values to host parameters using sqlite3_bind_ interfaces.Create the object using sqlite3_prepare_v2().The life of a statement object goes something like this: UPDATEs in SQLite when binding data are a complete transaction, meaningĮach sent row to be updated requires: Prepare/Bind/Step/Finalize statements unlike the INSERT which allows the use of the reset function So I assume Blob1 and Blob2 would not be replaced (as desired) Id INTEGER PRIMARY KEY ON CONFLICT REPLACE,īut the first two blobs will not cause a conflict, only the ID would If it was, I have three columns so it would actually look like: CREATE TABLE table1( I have not built a demo to test it, but it doesn't seem to be supported. I cannot confirm that syntax on the SQLite site for TABLE CREATE. (I am trying to avoid the overhead of SELECT in order to determine if I need to UPDATE or INSERT obviously) The ID is a primary key, so there will only ever be one record to UPSERT. If it does not exist, I want to INSERT the record with the default (NULL) value for the fourth column. Is there some clever way to do this in SQLite that I have not thought of?īasically I want to update three out of four columns if the record exists.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |